Metallurgy of steel wire rope electric hoist|Shandong Tailong Lifting Machinery Co., Ltd

Product description
YH type 1t~10t metallurgical wire rope electric hoist, is according to the requirements of the relevant regulations of the state, electric hoist design based on CD1/MD1 type wire rope electric hoist on the specifically applicable to the metallurgical industry, working level reached M6. YH type hoist will add a safety brake is directly arranged on the drum, reached the maximum safety hoisting products. The two series of products can be hoisting molten metal, but at -10 DEG C low temperature or high temperature above 50 DEG environment, in danger of explosion, full of sulfuric acid and other corrosive gas places, toxic, flammable in lifting places prohibit the use, to ensure safe and reliable. This product is recommended to use the remote operation.
YH type wire rope electric hoist electric hoist metallurgy working level M5, M6; the working environment temperature is not higher than 60 DEG C. , altitude below 1000m, the use of site shall not flammable and explosive and corrosive gases. Its suitable for three-phase AC, 50HZ, 380V. Electric hoist lifting work level mechanism for M6, a support (work) brake and safety brake. When in normal work which is arranged in the conical rotor motor on the brake on the transmission mechanism of the brake. If any link between the motor from the drive system to roll failure occurs, resulting in a hook and a heavy objects are speeding down, then by a set of safety brake drum drum brake to stop the will to prevent the load speeding down accident. Electric hoist not only is provided with double brake and is provided with a pair of lifting limit and down limit device, set at the same time overcurrent protection, under voltage protection, phase sequence protection, overload limiter, lifting weight down speeding power-off protection and so on the many kinds of safety protection device. Enhanced security performance of electric hoist. The insulation of the motor level to H level, the use of steel wire of 6 * 371WR steel wire rope to meet the needs of metallurgical production conditions. When the speed reducer and a motor is arranged under the high-temperature insulation protection function, in the installation of machine insulation board electric hoist reel below the housing design, high isolation of molten metal radiation. Operation type wire rope electric hoist the metallurgy by remote control or non following control mode is far away from the heat source to ensure the personal safety of the operator.
YH type wire rope electric hoist for metallurgical hoisting molten metal is special, the electric hoist is reasonable in structure, a first brake and motor as a whole, the safety brake drum brake in safety, no electricity (pure mechanical type), not by the electric effect. When the first brake when in normal work, the safety brake does not work, when the first brake failure or other parts damaged causing heavy fall, safety brake immediately safety braking, to ensure adequate safety hoisting molten metal. New metallurgical wire rope electric hoist is a square structure, beautiful appearance and the whole uses the modular design, each part adopts a detachable bolt connection, easy to product parts interchangeability and general add that